Корка KB112-01RE Столешница в стиле детского ухода в Столке ухода за детьми.
Цена: 64 532руб. (¥3650)
Артикул: 41802601149
Вес товара: ~0.7 кг. Указан усредненный вес, который может отличаться от фактического. Не включен в цену, оплачивается при получении.
Описание товараПродавец:top0103
Рейтинг:
Всего отзывов:0
Положительных:0
Добавить в корзину
Другие товары этого продавца
¥320856 718руб.
¥6940122 700руб.
¥5329 502руб.
¥1172 104руб.
KB1112-01R
Материал:
FDA одобряет полиэтилен с высокой плотностью (глазирован).
Инструкции по установке и оборудование включены.На шести языках и информации о безопасности.Изменяющаяся площадь поверхности формы волны составляет 379 квадратных метров.(2445 кв.
работать:
Используйте счетчики в ванной, чтобы иметь более богатое пространство, чем стены.Полиэтилен с высоким концентрацией не имеет острых углов, и его легко чистить и сопротивляться росту бактерий.
  Место происхождения: Соединенные Штаты
MATERIALS:
FDA approved thermoformed high-density polyethylene. Mounting instructions and hardware
included. Contoured changing surface is 379 sq. in (2445 sq. cm) and comes complete with nylon
safety straps.
OPERATION:
For use in restrooms where counter space is more abundant than wall space. High-density
polyethylene has no sharp corners, is easy to clean and resists odors and bacterial growth.
Warning: To ensure that the unit supports the intended loads, baby changing stations must be
properly installed according to the manufacturer’s instructions.
SPECIFICATION:
Baby changing station shall be durable, high impact polyethylene body. Design of unit shall be
counter recessed mounted. Bed shall have smooth concave changing area with a nylon safety strap
and universal instruction graphics. Unit shall be backed by manufacturer’s 5-year limited warranty on
materials and workmanship and include a provision for replacement caused by vandalism. Unit shall
be manufactured in the U.S.A.
INSTALLATION:
To ensure proper installation and compliance to building codes, it is recommended that a qualified
person or carpenter perform the installation of the unit.
Drilling Holes and Mounting the Station
1. Remove the station from the shipping container and check
for any freight damage.
2. Remove the rough opening template from the shipping
carton. Seperate the oval template from the cardboard
sheet. Use template to trace rough opeining to allow saw
access. Cut out rough opening.
3. Construct under counter support as shown in the
illustration. Support should be 3” below bottom of mounting
surface.
4. Place unit onto counter surface in desired position. Using
the unit’s mounting holes as a guide, mark the screw hole
locations with a pencil. Remove unit and drill holes with
a 5/32” (3.97 mm) diameter drill bit. Drill down¾” (19.05
mm) deep. Place the unit onto counter surface using the
drilled holes as a guide. Screw fasteners through holes
into countertop surface. Apply a suitable water sealant (not
provided) such as silicone around the base of the unit.
5. Fill the built-in dispenser with sanitary bed liners.
Replacement parts and additional liners can be purchased
from your local distributor or by calling toll free 888.733.3456 or 303.539.8300 in the U.S.A.
Caution: Drill carefully through ceramic tile and other hard counter top materials.